Cleaning And Maintenance - Baumatic AS15.1AL-B User And Installation Instructions Manual

CLEANING AND MAINTENANCE

Important: do not use water pressure cleaners or steam cleaners.
Exterior of the oven
Clean with a damp cloth. If it is very dirty, add a few drops
of washing up detergent to the water. Wipe with a dry cloth.
Do not use corrosive or abrasive detergents, which dull the
surface. In the event that one of these products comes into
contact with the oven, immediately clean it using a damp cloth.
Slight differences in colour on the front of the appliance are
determined by the different materials used, such as glass,
plastic and metal.
Accessories
Soak the accessories in water with washing up detergent imme-
diately after use. Food residues can be easily removed using
a brush or sponge.
Oven cavity
Do not use abrasive cleaners or pan scourers. Use special
oven cleaners and follow the manufacturer's instructions.
After every use, wait for the oven to cool then clean it to
prevent the build-up of baked-on food residues.
With long cooking times or when cooking on different
levels, especially food with a high water content (pizzas,
stuffed vegetables, etc.), condensation may form on the
inside of the doors and the seal. When the ovens are cool,
dry the inside of the doors with a cloth or sponge.
Clean the glass of the doors with a suitable liquid detergent.
Replacing the bulbs
Warning: Disconnect the appliance from the power
supply. To remove the side runner frame, push it
simultaneously down and towards the centre of the oven
(A-fig.1). Then lift the side runner frame upwards
to release it from the cavity wall (B-fig.1).
Lower cavity: remove the protective glass cover by
turning it anti-clockwise. Unscrew the faulty bulb and
discard safely, replace it with the new bulb and refit
the cover (fig.2). To refit the side runner frame, follow
the steps above in reverse order.
Upper cavity: remove the glass cover using a screw-
driver (fig.3). Change the bulb and refit the glass cover
by pressing it slightly.
To refit the side runner frame, follow the steps above
in reverse order.
Fig. 1
Fig. 2
.
Fig. 3
19