Before Initial Use; Connecting The Device - Beem HF-929TS Instruction Manual

25
16 – Set temperature
17 – Programme selection
18 – Set timer
19 LED display showing set temperature / duration
20 – Programme Chips
21 – Programme Meat
22 – Heating
23 – Programme Prawns
Not shown:
• Ventilation slits (on back of device)
• Operating instructions

Before Initial Use

NOTES
• Always set up the device with a clear space at the sides (at least 20 cm) and clear
space above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is
resistant to splashing fat.
• The surfaces of furniture may possibly contain elements which can attack and
soften the adjustable feet of the device. If necessary, place a suitable pad below
the adjustable feet.
• There may still be some production residues on the device. To avoid harmful
effects to your health, clean the device thoroughly before you fi rst use it (see
the "Cleaning and Care" chapter).

Connecting the device

1. Clean the device and all accessories thoroughly (see the "Cleaning and Care" chapter).
2. Set up the device in a suitable location, following the safety instructions and the notes
provided at the beginning of this chapter.
3. Fully unwind the mains cable.
4. Insert the mains plug into a properly installed plug socket that is easily accessible.
Two signal tones will be heard and all the elements in the display are briefl y illuminated.
After that the illumination of all elements switches off again, with the exception of
Field (15). The device is in standby mode.
01359_DE-EN-FR-ES-IT_A5_V2.indb 25 01359_DE-EN-FR-ES-IT_A5_V2.indb 25
EN
14.05.2018 14:07:38 14.05.2018 14:07:38