Binding - Enabling Avc; Binding - Disabling Avc - Arrma VORTEKS 4x4 3S BLX Vehicle Get Started

Binding - Enabling AVC

Connect a fully charged battery
pack to the ESC.
BRAKE/
REVERSE
Go to full brake on the
transmitter and back to neutral.
Orange light will go off when
moving the trigger and go back
to solid when accepted.
The sytem is now bound and the AVC function is enabled. The ST Rate (12) now controls the amount of AVC gain the vehicle has and does NOT

Binding - Disabling AVC

1..2..hold
Press the ESC power button and
quickly press the bind button
on the receiver 3 times. On the
third press keep holding the bind
button.
The sytem is now bound and the AVC function is disabled. The ST Rate (12) now controls the amount of steering lock the vehicle has and does
CAUTION: When the bind process is complete, the throttle and steering channels are active. Keep hands and loose
objects away from all spinning parts on the vehicle.
Once the binding process is complete you need to calibrate your ESC (see page 17). After calibrating the ESC and setting up
your trims/Reverse switches as required, to enable AVC you will need to repeat the binding - enabling AVC process 1 more
IMPORTANT: You must rebind the transmitter and receiver if you:
Change the servo reversing after binding
Change the travel after binding
Change the receiver mounting orientation
Want to use the receiver with a different model memory
IMPORTANT: keep the vehicle stationary when binding
Press and hold bind button
on the receiver then press
the power button on the ESC.
Orange light on receiver will
flash rapidly.
RIGHT
Go to full right on the transmitter
and back to neutral. Orange
light will go off when moving the
steering wheel and go back to
solid when accepted.
alter the steering rate.
The Orange light on receiver will
flash rapidly, you can remove
your finger from the receiver
bind button when this happens.
NOT alter the AVC settings.
time. AVC will then be active and calibrated correctly.
Whilst holding the bind button
on the transmitter press the ON
button. Wait until the orange
light on the receiver goes solid.
LEFT
Go to full left on the transmitter
and back to neutral. Orange
light will go off when moving the
steering wheel and go back to
solid when accepted.
Whilst holding the bind button
on the transmitter press the ON
button. Wait until the orange
light on the receiver goes solid.
Install the receiver in a different vehicle.
Are using the receiver in 5.5ms and want telemetry, you must rebind
in 11ms.
Are using the receiver with a DSMR transmitter and you change
the frame rate in the transmitter.
22
ACCELERATE
Go to full throttle on the
transmitter and back to neutral.
Orange light will go off when
moving the trigger and go back
to solid when accepted.
Turn off the ESC and then turn
off the transmitter. Binding is
complete.
Turn off the ESC and then turn
off the transmitter. Binding is
complete.
WWW.ARRMA-RC.COM