Maintenance And Cleaning; Replacing The Batteries; Troubleshooting - Princess 2954 User Instructions

7 Read the weight.
8 Remove the product (where relevant,
with the container) from the appliance.
The appliance may display a negative
weight. A '-' sign will then be shown at
the left of the display.
9 Press the on/off and reset button for
1 second to switch off the appliance.
The appliance will also switch off
automatically when it is not used for
1 minute.
Setting the timer
You can set the timer whenever you wish.
1 Open the cover.
2 Press the on/off and reset button to
switch on the appliance. '888' will be
shown on the display, and '0g' will ten
be shown after 1 second (default
display).
3 Press either 'timer -' or 'timer +' to
switch on the timer. A clock ( ) will be
shown at the left of the display. 'min'
and 'sec' are shown at the top of the
display. '00:00' is shown in the middle of
the display.
4 Press 'timer +' to increase the time in
intervals of 30 seconds. The maximum
time is 90 minutes.
5 Press 'timer -' to decrease the set time
in intervals of 30 seconds (you cannot
set a negative time). Keeping 'timer +'
or 'timer -' pressed in will increase the
speed at which the time is increased or
decreased.
6 Press the g/oz and start/stop button to
switch on the timer. You can interrupt
the timer by pressing the g/oz and start/
stop button. Press the button again to
restart the timer.
7 The timer counts back to '0'. When
there are 5 seconds left the timer emits
a brief beep every 0.5 second. When
the timer reaches 0, then '00:00' will
flash on the display for 10 seconds.
Press any button to stop the beep.
8 Press the on/off and reset button to
return to the default display of the
weighing mode. You can also do this
while the timer is running; however, this
will stop the timer. You will then need to
set the timer again.
9 Press the on/off and reset button to
switch off the appliance. The appliance
will also switch off automatically when it
is not used for 1 minute.
Maintenance
and cleaning

Replacing the batteries

Replace the batteries immediately if the
battery indicator at the top left of the
display begins to flash.
1 Switch off the appliance.
2 Remove the battery cover.
3 Replace the batteries.
4 Fit the cover to the battery
compartment.
Cleaning the Kitchen Scale
• Do not immerse the appliance in
water, or in other liquids. If this
happens do not use the appliance any
more; dispose of the appliance.
• Never use corrosive or scouring
cleaning agents.
1 Clean the control panel solely with the
special microfibre cloth supplied with
the appliance. Do not moisten the cloth.

Troubleshooting

A spanner is shown at the bottom left of
the display (Fig. 2; 5) in the event of a
specific malfunction. Rectify this
malfunction using the following procedure:
1 Switch off the appliance by pressing the
on/off and reset button for 1 s.
2 Remove the batteries, and then fit them
correctly in the battery compartment
(see 'Replacing batteries').
New Classics Kitchen Scale Article 2954
5