Martin TRACKPOD Getting Started page 14

Stage
4
right
FIGURE 5 - Stage terminology and location of stagemarks.
Note that stagemarks 2-C-4 must be on a straight line.
Measure the distances between the stagemarks as shown in Figure 5, six
in total. The measurements have to be in centimetres if metric units are
chosen in the preferences and in feet and inches if Imperial units are
chosen. Place laser reflectors exactly over the stagemarks: this is not
essential but it will help you see the laser. The supplied laser reflectors
are "pie slices" designed to be assembled as cones which provide an
almost perpendicular surface to shine on. Use the sticky tape on the
back of the slices to fold them into a cone. The next procedure will
require the use of the laser calibrator.
section of this manual (pages 4-5) before attempting this step.
The first screen that appears on the TrackPod display when it is con-
nected to a PC that runs the software, shows the TrackPod number and
options for playback or calibration. From this screen, do the following:
• Press number 2 to select the option "Calibration".
• Press 1 "TrackPod" to select a TrackPod Calibration.
• Enter the Head ID Number (printed on the TPod's head) and press OK.
• In the next screens, enter the distance between the different
stagemarks, in metres or feet / inches depending on which units are
selected in the preferences. Press the OK button to go forward and the
cancel button to go back.
• Enter a height for the stagemarks, if any, and press OK.
Page 14
Upstage
1
?
C
?
?
3
Downstage
Public
Make sure to read the "warnings"
?
Stage
2
?
left
?
Getting Started
www.audiovias.com