Page 1
PORTABLE TWO BURNER TABLE TOP GAS GRILL ITEM # 95541 OWNER’S MANUAL AND SAFETY INSTRUCTIONS SAVE THIS MANUAL. KEEP THIS MANUAL FOR SAFETY WARNINGS, PRECAUTIONS, ASSEMBLY, OPERATION, INSPECTION, MAINTENANCE AND CLEANING PROCEDURES. WRITE THE PRODUCT’S SERIAL NUMBER ON THE BACK OF THE MANUAL, OR THE MONTH AND YEAR OF PURCHASE IF PRODUCT HAS NO SERIAL NUMBER FOR QUESTIONS, PLEASE CALL CUSTOMER SERVICE: 909.628.4900...
Page 2
SAFETY INFORMATION SAFETY INFORMATION Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in injury and/or property damage. Save all warnings and instructions for future reference. The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur.
LP GAS CYLINDER: This grill is designed and intended to be used with a disposable propane cylinder with a nominal fuel weight of 1 lb. Such a cylinder is approximately 4” in diameter and 7” long. The BARTON Table Top Grill does not include an LP gas cylinder. This must be purchased separately and be found at most hardware stores.
Page 4
SAFETY INFORMATION SAFETY INFORMATION The LP gas cylinder shall be used only outdoors in a well-ventilated space and not in a building, garage, or any other enclosed area. The Table Top Grill may be stored indoor if the LP gas cylinder is removed and stored outdoor.
ASSEMBLY Fig 1: Install the grease tray under the firebox as Fig 2: Put the flame tamer on the burner then put shown below. the grid on the firebox. Connect he gas hose to the unit tightly as shown below. TANK INSTALLATION If the outdoor cooking appliance is not in use, the gas must be turned “OFF”...
SAFETY INFORMATION OPERATION LEAK TESTING GENERAL Although all gas connections on the grill are leak tested at the factory prior to shipment, a complete ga tightness check must be performed at the installation site due to possible mishanding in shipment, or excessive pressure unknowingly being applied to the unit.
DISCLAIMER PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT.
Need help?
Do you have a question about the 95541 and is the answer not in the manual?
Questions and answers