Rear Inlay Assembly - Lenovo Moto Z4 Service And Repair Manual

Lenovo Moto Z4
Level 2 – Service and Repair Manual

Rear Inlay Assembly

Description
Stingray RearCVR FLSHGRY Etching NA
Stingray RearCVR FLSHGRY Etching VZW
Stingray RearCVR WHT Etching VZW
Stingray FRU RearCVR FLSHGRY
Stingray FRU RearCVR WHITE
HSG,REAR,STINGRAY,HSG_INLAY_ FOLES_BLACK
LENS,OTHR,INLAY FOLES BLK AG VZW
HSG_INLAY_ FOLES_WHITE,AG,VZW
DICUT,PSA,PSA,DIECUT_FOLES_INLAY_PSA
1. U se cotton swabs and ISP Alcohol to
4 2 7 B
clean the Rear Inlay bonding ledge on the
Rear Housing. The Rear Inlay bonding
ledge is highlighted in the photo.
/ / CAUTION //
1 6 2 3 B
Rear Inlay bonding ledge cleaning is critical to
the phone's water resistance. You must
thoroughly clean the surface with ISP Alcohol
and allow it to dry completely before applying
3M AP-111 Adhesion Promoter.
2. W ait for the ISP Alcohol to dry
4 2 8 B
completely.
/ / CAUTION //
1 6 2 4 B
D o not use the same cotton swabs to clean
1 5 4 7 B
with ISP Alcohol and apply 3M AP-111
Adhesion Promoter. The Rear Inlay will not
properly adhere to the Rear Housing if the
cotton swabs are reused. The cotton swabs
may be used for 2 applications of the same
chemical, but then must be discarded.
3. Repeat steps 1-2 one time.
4. U se clean cotton swabs to apply 3M AP-
4 3 0 B
111 Adhesion Promoter to the Rear Inlay
bonding ledge.
5. Wait for the 3M AP-111 Adhesion
Promoter to dry.
PAGE 97
Reference #
5
6
27
Lenovo Confidential Restricted:
Do not share without consent from Lenovo