Advertisement
471 US Hwy 250 East, Ashland, Ohio 44805
PH: 419-207-9400
FX: 419-207-8031
_______________________________________________________________________________
INSTALLATION AND SERVICE INSTRUCTIONS
FOR "KL" GUIDE RAIL SYSTEM /SUBMERSIBLE
NON-CLOG SEWAGE PUMPS
_______________________________________________________________________________
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Keen Pump KL
Summary of Contents for Keen Pump KL
- Page 1 471 US Hwy 250 East, Ashland, Ohio 44805 PH: 419-207-9400 FX: 419-207-8031 _______________________________________________________________________________ INSTALLATION AND SERVICE INSTRUCTIONS FOR “KL” GUIDE RAIL SYSTEM /SUBMERSIBLE NON-CLOG SEWAGE PUMPS _______________________________________________________________________________...
- Page 2 Read all instructions in this manual before operating pump. Most accidents can be avoided by using COMMON SENSE. KEEN PUMP is not responsible for losses, injury or death resulting from a failure to observe these safety precautions, misuse, abuse or misapplication of pumps or equipment.
- Page 3 System Description: For the Keen “KL” Rail System, the pump is raised and lowered in the basin on dual pipe rails. A hydraulic sealing flange at the pump discharge allows the pump to be connected and removed from the discharge elbow with ease at any time, without entering the wet well.
- Page 4 4. Basin Cover(s): The basin cover for the sump and valve box can either be poured concrete or precast. If Keen Pump-supplied door and frame assemblies are used, locate the concrete openings with respect to the discharge elbow mounting studs as shown in the installation drawing data. If the covers are poured, place the door and frame assembly inside the concrete form and position per installation drawing data.
- Page 5 Pumps alternate operation on each successive cycle with a Keen Pump Panel. The alarm level is usually set above the override level as it is possible for one pump to fail and the other to operate on the override level with the sump level never reaching the alarm level.
- Page 6 PUMP OPERATIONS WARNING: Before handling these pumps and controls, always disconnect the power first. Do not smoke or use sparkable electrical devices or flames in a septic (gaseous) or possible septic basin. See Pump Installation and Service Manual for submersible pump operation on starting system. Clean all trash and sticks from basin and connect pump to piping.
- Page 7 PUMP TROUBLESHOOTING WARNING: Before handling these pumps and controls, always disconnect the power first. Do not smoke or use sparkable electrical devices or flames in a septic (gaseous) or possible septic basin. The following is a list of common problems and possible solutions. Refer to Pump Installation and Service Manual for any necessary adjusting, dismantling or repair work required on the pump.
- Page 8 LABOR, ETC., COSTS: Keen Pump shall in no event be responsible or liable for the cost of field labor or other charges incurred by any customer in removing and/or reaffixing any Keen Pump product, part or component thereof or any temporary pumping of other equipment.
Need help?
Do you have a question about the KL and is the answer not in the manual?
Questions and answers