Wickes PGA1156 Manual page 11

to the operator.
Tighten clamping screw (a) with the hey key (12).
Disc Guard for Cutting (7)
WARNING! For cutting metal, always work with
the disc guard for cutting. The disc guard for
cutting is mounted in the same manner as the disc guard
for grinding.
4. FITTING THE DISCS (NOT SUPPLIED) (See Fig. C)
Put the inner flange (9) onto the tool spindle. Ensure it is
located on the two flats of spindle (See Fig. C1).
Place the disc on the tool spindle and inner fIange (9).
Ensure it is correctly located.
Fit the threaded outer flange making sure it is facing
in the correct direction for the type of disc fitted. For
grinding discs, the flange is fitted with the raised portion
facing towards the disc. For cutting discs, the flange is
fitted with the raised portion facing away from the disc
(See Fig. C2).
Press in the spindle lock button (3) and rotate the spindle
by hand until it is locked. Keeping the lock button pressed
in, tighten the outer flange (10) with the spanner provided
(See Fig. C3).
Fig. B2
Fig. C1
a
9
10
Cutting disc (not supplied)
Fig. C2
Fig. C3
11
Grinding disc (not supplied)
b
9
10