Asko WM75.B Instructions For Use Manual page 41

FAILURE DISPLAY
In case of a failure while a program is in progress, the relevant Error X is indicated on the display unit.
Error 3
Errors indicated on the display unit may include the following:
Error Error indication on the display
unit
E0 INCORRECT SETTINGS
E1 THERMISTOR ERROR
Temperature sensor error.
E2 DOOR LOCK ERROR
E3 WATER FILLING ERROR
E6 HEATING ERROR
Water heating error.
E7 DRAINING ERROR
Water draining error.
E10 WATER LEVEL SENSOR ERROR
E11 OVERFLOW
Water overflowing.
E12 MOTOR ERROR / MOTOR
CONTROL ERROR
Press the INFO button to display the
Info Exit
error description.
Switch off the appliance and turn it back
on.
5
What to do?
Restart the programme. If the error reoccurs, call a service
technician.
• Inlet water too cold. Repeat the washing program.
• If the appliance reports this error again, call a service
technician.
Turn the appliance OFF and then switch it again ON. Start the
program again. If the error reoccurs, call service technician.
Check the following:
• is the water inlet valve open,
• is the filter on the water inlet hose clean,
• is the water supply hose deformed (clipped, clogged etc.),
• is the pressure in the water mains between 0.1 and 1 MPa
(1–10 bar).
Then, press the Exit button to resume the program.
If the error reoccurs, call a service technician.
Restart the program. If the error reoccurs, call a service
technician.
Check the following:
• is the pump filter clean,
• is the drain hose clogged,
• is the drain clogged,
• is the drain hose fitted at the right height (see chapter on
drain hose installation in the instruction manual).
Then, press the Exit button again. If the error reoccurs, call
a service technician.
Turn the appliance OFF and then switch it again ON. Start the
program again. If the error reoccurs, call service technician.
If there is water in the drum that exceeds a certain level,
and an error is reported on the display unit, the washing
program will be interrupted and water will be pumped out of
the washing machine. Restart the programme. If the error
reoccurs, call a service technician.
If there is water in the drum that exceeds a certain level, and
an error is reported on the display unit, while the washing
machine continues to add water, close the water tap and call
a service technician.
Restart the program. If the error reoccurs, call a service
technician.
41