Troubleshooting - Banner American Easy-Lam II Operating Instructions Manual

NOTE: You may want to run a test lamination first, as any item that passes
between the heat shoes will be laminated and cannot be recovered until it
exits the rear of the laminator.
7. Additional items may be fed in sequence, keeping enough distance
between sheets for trimming.
8. After the last item has exited the pull rollers, turn the motor switch
off.
9. Use the zippy cutter to cut across the film to remove the laminated
items from the unit.
10. The Easy-Lam II has mounting capability up to 3/16". Please refer
to the video for instructions.
11. The 5 mil option switch is a factory installed option which gives
the user the capability of laminating 5 mil laminate.

Troubleshooting

The following guide will assist you with most problems that may be
encountered when laminating.
PROBLEM:
ACTION:
PROBLEM:
Laminator is inoperative. Motor does not run and the
indicator lights are out.
Unit may be unplugged.
Ensure that your circuit breaker has not tripped.
Fuse may have blown. Replace the fuse (in back next to
the power cord) with 15amp BUSS (MDA-15).
Laminating film and item being laminated move through
the laminator erratically.
15