gAvilar gDC-100 Installation And Operation Manual page 3

1. gDC-100 coupling
3. gDC-100 strap
Please read this manual carefully before
installation and use of the gDC-100.
Note gAvilar warranty obligations do not apply in
case malfunctions due to inexpert or
inappropriate use.
1. Introduction
The gDC-100 is a substitute of the BDA 10
and is therefore compatible with the
®
PLEXOR * inspection system for pressure
regulating stations. The gDC-100 shall be
placed in the sensing line towards a safety
provision of a pressure regulator station.
The functional pressure that occurs, shall
not exceed a value of 100 bar. Use the
®
matching PLEXOR * connection to a
pressure regulating station.
Copyright © gAvilar B.V.
GA-02.116-NL/EN/DU-01.04.20
This controlled document is subject to change. For latest revision visit our website at
* PLEXOR is a registered trademark of Wigersma & Sikkema B.V.
Installation and operation of gAvilar
Diagnostic Coupling gDC-100 PN16
2. gDC-100 cap
2. Safety measures
•
Work according to applicable
regulations and guidelines.
•
For the correct operation of the gDC-
100, the use of clean and condensate-
free natural gas (CNG) is necessary.
•
The user of the PLEXOR
system must be qualified in agreement
with the nationwide regulations to
perform the functional inspections on a
pressure regulating station.
•
Before using the device, the user must
have had a PLEXOR
system training.
•
A defective coupling must be replaced
with a new one. Please send the
defective coupling for analysis to
gAvilar B.V..
Product information: +31 85 4897 130
www.gavilar.nl
Instruction sheet
67037
Rev. c
®
* inspection
®
* inspection
info@gavilar.nl
3