Installing The Spray Gun Washer - WALMEC Walcom Easy Operating And Maintenance Handbook

INSTALLING THE SPRAY GUN WASHER

a) Place the base vertically; the two brackets for the solvent bins should be at the bottom.
b) For the EASY/S model, assemble the knob at the centre of the hatch and tighten the screw provided. The hatch has
a pin at the bottom left: place this pin in the hole on the left of the base. Then line up the top hatch hole and top
base hole and fit the pin in the small bag containing the knob and screw.
c) Fit the washing chamber on the base, placing the pins in the chamber into the holes in the base.
d) Fit the discharge hose which you will find loose in the packing case.
e) Place the two containers on the base brackets: one for clean solvent (right) and the other empty (left) to discharge
the dirty solvent. Fit the tank discharge hose to the empty bin (fitted as at point 7) and the suction hose from the
left (the dirty solvent). Fit the two hoses for the suction of lean solvent from the right.
f) Fit the hose into the chimney to convey fumes outside the room
g) Hook up the compressed air (max 7 bar) to the start-up cock at the top of the chamber. The spray gun washer is
now ready for use.
5