Fortinet FIM-7921F Manual page 20

Hardware installation
To complete this procedure, you need the following equipment and tools:
a FortiGate-7000 chassis with a FIM-7921F module installed
l
an electrostatic discharge (ESD) preventive wrist strap with connection cord
l
a Phillips screwdriver
l
1. Shut down the module operating system properly.
To avoid potential hardware problems, always shut down the module operating system properly before removing the
module from a chassis slot or before powering down the chassis. To shutdown the module, connect to the module GUI
and select Shutdown from the administrator menu. Or, from the module CLI, enter the execute shutdown command.
2. Disconnect all cables from the module, including all network cables and USB cables
or keys.
FIM-7921F 6.2.6 Interface Module Guide
Do not carry the FIM-7921F by holding the module levers or secure screws. When inserting or
removing the FIM-7921F from a chassis slot, handle the module by the front panel. The levers
are not designed for carrying the module. If the levers become bent or damaged, the FIM-
7921F may not align correctly in the chassis slot.
FIM-7921Fs must be protected from static discharge and physical shock. Only handle or work
with FIM-7921Fs at a static-free workstation. Always wear a grounded electrostatic discharge
(ESD) preventive wrist strap when handling FIM-7921Fs. ( An ESD wrist strap is not visible in
the photographs below because they were taken in an ESD safe lab environment.)
Fortinet Technologies Inc.
20