Charging the Earphones
Red LED indicates low battery.
1.
Connect the earphones to a charging device using the supplied USB cable.
2.
The LED is red while charging.
3.
When fully charged, the LED turns off.
Warning: Before charging, make sure the product is at room temperature, between 10 to 45°C (50 to 113°F).
Note: Use this product only with an agency approved power supply which meets local regulatory requirements (e.g., UL, CSA, VDE, CCC, INMETRO).
Specifications
Antenna Information:
•
Type = Chip
•
Gain = +1.6 dBi
Bluetooth 5:
•
Operating frequency = 2402MHz-2480MHz
•
Modulation scheme = FHSS
•
RF power = +7.45dBm (E.I.R.P.) (for EU)
Supported Codecs:
™
•
aptX
•
aptX HD
•
aptX Low Latency
•
SBC
•
AAC
Safety Information
WARNING
•
Follow instructions from manufacturer.
•
Product battery may explode or release toxic materials. Risk of fire or burns. Do not open, crush, modify, disassemble,
heat above 140°F (60°C), or incinerate.
•
Attention should be drawn to the environmental aspects of battery disposal.
•
Product shall not be exposed to excessive heat such as sunshine, fire, or the like.
Shure Incorporated
5/9