When using electrical equipment, basic safety precautions should always be followed including the following:
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS
2. Disconnect power before performing work on electrical equipment.
3. Do not use outdoors.
4. Do not let power cords touch hot surfaces and do not mount near gas or electric heaters.
5. Use caution when servicing batteries. Battery acid can cause burns to skin and eyes. If acid is spilled on skin or
eyes, flush with fresh water and contact a physician immediately.
6. Equipment should be mounted in locations and/or at heights where unauthorized personnel will not readily subject it
to tampering.
7. The use of replacement parts or accessory equipment not furnished by Beluce Canada Inc., may cause equipment
failure and will void the warranty.
8. Do not use this equipment for other than its intended purpose.
9. Servicing of this equipment should be performed by qualified service personnel.
10. SAVE THESE INSTRUCTIONS!
Lighting
Load
Input/Output:
120VAC / 120VAC, 60Hz
NO transformer if both input and output voltages are 120V
Batteries MUST be connected for Inverter to turn ON
N-ON (Normally ON): unit will always provide AC output to lighting load when AC input is available, and during AC input failure
N-OFF (Normally OFF): unit will provide AC output to lighting load only when AC supply input fails
MAXIMUM SURGE VALUES: Inrush / Peak current factor of the lighting load should be considered while sizing
lighting load for the inverter
•
Nova UAC-P
-
Beluce Canada Inc., 3900 14th Avenue, Markham, ON L3R 4R3 Tel: (905) 948-9500 Fax: (905) 948-8673
926000090
INSTRUCTIONS
IMPORTANT SAFEGUARDS
OVERVIEW
AC Input
120V
Button
AC Output
120V
1200W for 0.5 seconds
Test
Inverter Box
N-ON / N-OFF
Switch
Nova UAC (NV-UAC-P)
Pure Sine Wave
250W & 550W
Batteries
06/09/2019