Operation - Husky HYLS-7208 Use And Care Manual

Operation

1
Removing the drawers
□
Pull the drawer out so that it is almost fully extended.
□
On the RIGHT-hand side, push the black release lever DOWN.
□
On the LEFT-hand side, pull the black release lever UP.
□
While holding the levers as instructed, pull the drawer forward until
released from the slides attached to the workbench.
2
Replacing the drawers
□
To replace the drawer, pull the slides out completely.
□
Insert the brackets on each side of the drawer slides
into the corresponding slots on the workbench slides,
making sure they are properly positioned.
□
Once the brackets are inserted into the slots,
completely close the drawer to set all slides in their
proper positions.
3
Locking and unlocking
NOTE: Drawer lock and cabinet lock use different
keys. Match the code on the lock to the code on
the key.
□
To lock the unit, insert the key (G) into the lock cylinder
and turn it 1/4-turn to the left. Then remove the key.
□
To unlock the unit, insert the key (G) into the lock
cylinder and turn it 1/4-turn to the right. Then remove
the key.
NOTE: The drawers must be fully closed before
locking or unlocking the unit.
8