Electric Reactor Kit Installation 3. Wait for heaters and fluid to cool. 5. Remove old parts. 4. Remove back heater cover (C). See F . 1. a. If replacing an existing rupture disk assembly (D), remove old assembly from heater inlet NOTE: Use dropcloth or rags to protect Reactor and manifold (M).
Page 3
Electric Reactor Kit Installation Apply PTFE tape and thread sealant to threads. 245962 and 245975 Heaters 245963 Heaters . 2. Install Rupture Disk Assemblies 309969C...
Hydraulic Reactor Kit Installation Hydraulic Reactor Kit Installation Disassembly Assembly 1. Turn main power OFF . Disconnect power Using a wrench on the rupture disk red housing can supply. cause damage, resulting in a lower rupture pressure. To tighten the rupture disk assembly (D), use a 2.
Page 5
Hydraulic Reactor Kit Installation Hydraulic Reactors Pumpline Apply PTFE tape and thread sealant to threads. ti9874a Reactor H-VR Pumpline Apply PTFE tape and thread sealant to threads. r_256886_313539_3 . 3. Hydraulic Systems 309969C...
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.