Kenwood NXR-700H Service Manual page 120

NXR-700H
Item Condition
21. Maximum 1) Channel: 3 (Center)
Deviation Wide/Narrow: Analog Wide
(Analog) Connect the deviation meter
to the TX ANT end via the ATT.
Deviation meter setting
HPF: OFF
LPF: 15kHz
De-emp: OFF
Detector: +peak, –peak
AG setting: 1kHz/45mVrms
(Sine wave, Terminal load)
2) Channel: 3 (Center)
Wide/Narrow: Analog Narrow
Connect the deviation meter
to the TX ANT end via the ATT.
AG setting: 1kHz/55mVrms
(Sine wave, Terminal load)
22. Standard 1) Channel: 3 (Center)
Modulation Wide/Narrow: Analog Wide
Check Connect the deviation meter
to the TX ANT end via the
ATT.
Deviation meter setting
HPF: OFF
LPF: 15kHz
De-emp: OFF
Detector: (p-p)/2
AG setting
: 1kHz/±3kHz DEV
(Sine wave, Terminal load)
2) Channel: 3 (Center)
Wide/Narrow: Analog Narrow
Connect the deviation meter
to the TX ANT end via the
ATT.
AG setting
: 1kHz/±1.5kHz DEV
(Sine wave, Terminal load)
23. QT 1) Channel: 3 (Center)
Deviation Wide/Narrow: Analog Wide
Connect the deviation meter
to the TX ANT end via the
ATT.
Deviation meter setting
HPF: OFF
LPF: 3kHz
De-emp: OFF
Detector: (p-p)/2
2) Channel: 3 (Center)
Wide/Narrow: Analog Narrow
120
ADJUSTMENT
Measurement
Test-
Unit Terminal Unit
equipment
Deviation Rear TX ANT
meter Front MIC
AG
DVM
Deviation Rear TX ANT
meter
Adjustment
Parts Method
PC ±4.1kHz ±0.2kHz
ADJ
Connect the deviation meter
to the TX ANT end via the
ATT.
±1.7kHz ±0.1kHz
Check 4.5mV±1.5mV
Connect the deviation meter
to the TX ANT end via the
ATT.
5.5mV±1.5mV
PC ±0.75kHz ±0.05kHz
ADJ
Connect the deviation meter
to the TX ANT end via the
ATT.
±0.35kHz ±0.05kHz
Specifi cations / Remarks