Assembling Your Smoothie Blast - Back to Basics SITSJRLP Instruction Manual

Before assembling your Smoothie Blast
in warm, soapy water, rinse thoroughly and dry. Unscrew and disassemble the valve
for cleaning (see Cleaning Your Smoothie Splash
your smoothie maker, do not wash parts in the dishwasher.
1. Position the rubber gasket down onto the circular flat surface in the blade base.
2. Screw the blade base on the bottom of the blending jar by twisting the blade
base counter-clockwise until tightened. Make sure that the blade base is tightly
fastened to the blending jar and that the rubber gasket is properly compressed
between the blending jar and the blade base.
3. Lock the lid onto the top of the blending jar. Lock the clear lid cap in the center
of the lid or place the stir stick through the center of the lid if blending liquids or
frozen drinks.
4. Place the blending jar onto the motor base so that the bottom of the blade base
is sitting flat on the motor base.
5. Plug in the cord. Your smoothie maker is now ready to use.
Lid Cap
Lid
Blending Jar
Blender Cap
Dispensing Valve
A
SSEMBLING
Y S
OUR MOOTHIE
™
wash all parts, except for the motor base
™
4
™
B
LAST
section). To prolong the life of
Stir Stick
Rubber Gasket
Blade Base
Motor Base