Remove The Packaging; Set Up Your Filament Maker; Safety Instructions - 3devo COMPOSER & PRECISION Quick Start Manual

Warranty
For information about the
3devo warranty policy visit:
www.3devo.com/warranty

Remove the packaging

Remove the top accessory box. Then remove the top foam
blocks. Carefully place both arms beside the filament maker, lift
it out of the box and place it on a flat surface. Remove the plastic
cover bag from the filament maker. Finally remove and unpack
the accessories from the spooling area.

Set up your filament maker

1) Plug in the power cord and turn on
the power switch at the back of the filament
maker.
5) Put PLA granulate in the hopper.
9) Main screen will indicate that the system
is 'Heating' . Wait about 10 minutes and the
extrusion process will start automatically.
13) Cut the filament when the
set size is reached and start spooling.
Support
For more information or
technical support visit:
www.3devo.com/support
2) Press 'Activate' to unlock the full functionality
of the machine. For more information go to
www.3devo.com/activate
6) Take an empty spool
and mount it on the spool holder.
10) When the filament is extruding,
wait until about 20cm is out of the nozzle.
14) Guide the filament through
the positioner holes.

Safety instructions

Check if the voltage in your working station
corresponds to that of the purchased product.
Make sure the filament maker is placed in a well ventilated
room.
When using the filament maker with any material other
than 3devo PLA, thoroughly read ALL the safety
instructions of the manual on:
www.3devo.com/manuals
Do not touch the hot materials near the nozzle.
Be aware of heated and/or moving components.
3) Once you have read the information on
the activation page, enter the code you have
received in your e-mail and press 'Ok' .
7) Place spool holder
with spool on the spooling axis.
11) Open the puller clamp, then pull the
soft filament through the Optical diameter
sensor and puller.
15) Guide the filament through the spool (inner
hole).
4) Unwrap the hopper tube and place it on top
of the extruder hopper.
8) Push the menu button and click
"Start Extrusion" (with the PLA preset).
12) Go to "Start spooling" in the menu
and follow the steps on the screen.
16) Wait and watch as your first spool of
PLA filament is made.