Page 1
Page 1 GEN-8 Specs Power Requirements 400 ma @ 24VDC # of Burners / material 8 precision brass BTU Rating (variable) LP 18,104 maximum GEN-8 NG 21,816 maximum Cubic Ft CO2 per hour 22 SCFH Natural Gas (NG) Pressure 4.5” WC / 1.15 kpa...
Page 2
Bend the S hooks so that they are secure. long as the Propane gas pressure has been verified Verify the GEN-8 is hanging level. The GEN-8 has a safety to be regulated at 11” WC feature, the “tip over” switch, which will turn off the burners if it tips over or falls.
Page 3
The ignition module and firing sequence is activated by the Check and confirm that the gas connections are connected main power switch located on the side of the GEN-8. The properly. generator has power and is in operation if the green “Power On”...
Page 4
* A burner that burns almost invisibly with a clean blue- !!WARNING!! The GEN-8 produces up to 21,000 BTU’s of white flame are running correctly. heat at full capacity. Verify the area around the GEN-8 is not getting too hot for the surroundings.
Page 5
Should there be a gas smell in the area? NO. Turn off the For safer operation GEN-8 has an Electronic Ignition gas supply immediately, Do not turn on any electrical devices. Control Module that eliminates the “open” pilot flame. The Ventilate the area by opening vents, doors, or windows.
Page 6
Should the GEN-8 be buzzing and / or sparking? Yes, when the unit is firing you will hear “sparking” sounds. It will attempt this up to 5 times, before going into lock out mode.
Page 7
Page 12 GEN-8 IMPORTANT MESSAGE Read and understand this instruction manual BEFORE attempting to operate this product. Failure to do so could result in personal injury and / or property damage. made in china...
Need help?
Do you have a question about the GEN-8 and is the answer not in the manual?
Questions and answers