Table of Contents
Advertisement
5. If you have a sound card that can be connected to the drive, you
can also connect the drive (as Audio-Out) and the sound card (as
Audio-in) with a 4-pin audio cable.
If your mainboad is integrated with built-in sound system, plug the
4-pin audio cable into the CD-IN connector on the mainboard as
Audio-in.
6. Connect the USB cable at the back of the drive to the USB
header on the computer's mainboard. The red wire of the cable
needs to be plugged into Pin 1 on the board. If the connection is
correct, the lower LED on the front panel will light Yellow.
This drive supports USB 1.1 and if you connect to USB 2.0
connector, only transfer rate of USB 1.1 will be available.
RED WIRE
USB
RED WIRE
Signal
Red/Vcc
White/D-
Green/D+
Black/Ground
Braided Shield Ground
7. Re-attach the cover of the computer, and reconnect the power
cord and all cables to the computer.
IDE
Pin #
USB Header
1
2
3
4
5
Dual Digital Drive
Mainboard
5
Advertisement
Table of Contents
