Table of Contents
Advertisement
Dual Digital Drive
Improper or conflicting setting will cause the unit not detected by your
system.
Hardware Installation
1. Turn off the power to your computer system.
2. Disconnect the power cord and all cables from the back of your
computer, and then remove the cover of the computer.
3. Insert the drive into one of the vacant 5.25" drive bays and
secure it to your PC with all four mounting screws.
4. Connect one end of the 40-pin IDE cable to the IDE connector of
this drive and the other end to the IDE port on your mainboard.
Also, connect the power supply cable to the back of the drive.
Make sure to align and connect the red-edge of the IDE Cable to
Pin 1 on the drive.
4
CSEL
MASTER
SLAVE
JUMPER
Power In
Advertisement
Table of Contents
