Advertisement
5.5.3.
Press the ◄ ► key to select the battery rating:
SAE (CCA), EN, IEC, DIN, or JIS. Press 'ENTER' to confirm choice.
5.5.4.
Press the ◄► to input the battery capacity:
sAe (ccA): 40~3000
en: 40~2830
din: 25~1685
iec: 30~1985
Jis: battery type no. Press 'enter' to begin test.
5.5.5.
Press the ◄► to confirm the location of the battery if a surface charge is detected, follow the tester's
instructions to remove the surface charge, then test proceed as follows:
5.5.6.
Press the ◄► key to confirm the temperature of the tested battery.
5.5.7.
When the test is completed, the display shows the results as follows (press the ◄► key to select:
soH (stAte of HeAltH) or soc (stAte of cHArGe)).
good & pass
the battery is good & capable of holding a charge.
good & reCharge
the battery is good but needs to be recharged.
reCharge & retest
battery is discharged, the battery condition can not be determined until it is fully charged.
recharge & retest the battery.
bad & replaCe
the battery will not hold a charge, it should be replaced immediately.
bad Cell & replaCe
the battery has at least one cell short circuited, it should be replaced immediately.
test Code
Press 'enter' to get the test code for records.
note: under certain conditions the following messages may be displayed.
load error
the tested battery is bigger than 3000sAe (ccA), or the connection is not properly established. check the
capacity of the battery & make sure the clamps are properly connected.
24V systeM printing
To print a 24V system test result, the user must save the test results first. The test will be saved until you
connect to a 12V battery. the message to check printout will be displayed after you reconnect to the battery.
5.6.
systeM test
5.6.1.
Press 'enter' button, you will view the following screen.
5.6.2.
turn off all vehicle accessory loads such as lights, air conditioning, radio etc. before starting the engine.
5.6.3.
When the engine is started, one of three results will be displayed along with the actual measured result.
CranKing Volts norMal
the system is showing normal draw. Press 'enter' to perform the charging system test.
© Jack sealey limited
Original Language Version
select rAtinG
sAe
select cAPAcitY
XXXX sAe
test in VeHicle?
no
bAt. temPerAture
AboVe 32°f (o°c)?
Yes/no
Good & PAss
XX.XXV XXXXsAe
Good & recHArGe
XX.XXV XXXXsAe
recHArGe &
retest
XX.XXV XXXXsAe
bAd & rePlAce
XX.XXV XXXXsAe
bAd cell &
rePlAce
XX.XXV XXXXsAe
code
XXXXXXXXXX
loAd error
Print 24V sYstem
result?
Yes
sYstem test
XX.XXV
turn off loAds
stArt enGine
crAnKinG Volts
XX.XXV
normAl
bt2015 | issue:1 17/10/17
Advertisement
