Advertisement
5.4.4.
Press the ◄► key to input the battery capacity:
sAe (ccA): 40~3000
en: 40~2830
din: 25~1685
iec: 30~1985
Press 'enter' to begin test.
5.4.5.
Press the ◄► key to confirm the position of the battery if a surface charge is detected,
follow the tester's instructions to remove the surface charge.
5.4.6.
testing battery.
5.4.7.
Press the ◄► key to confirm the temperature of the tested battery.
5.4.8.
When the test is completed, the display shows the results as following
(Press the ◄► key to select: SOH (STATE OF HEALTH) or SOC (STATE OF CHARGE)).
good & pass
the battery is good and capable of holding a charge.
good & reCharge
the battery is good but needs to be recharged.
reCharge & retest
battery is discharged, the battery condition can not be determined until it is fully charged.
recharge & retest the battery.
bad & replaCe
the battery will not hold a charge, it should be replaced immediately.
bad Cell & replaCe
the battery has at least one cell short circuited, it should be replaced immediately.
test Code
Press enter to get test code for records.
5.5.
battery test
5.5.1.
Press the ◄► key to select Battery Test. There are 3 tests for selection:
stArt stoP
bAtterY test
sYstem test
Press 'enter' to proceed with the test for a regular starting battery.
5.5.2.
Press the ◄► key to select the battery type:
a) flooded
b) AGm flAt PlAte
c) AGm sPirAl
d) VrlA/Gel
Press 'ENTER' to confirm choice.
© Jack sealey limited
Original Language Version
set cAPAcitY
XXXX sAe
test in VeHicle?
no
testinG
bAt. temPerAture
AboVe 32°f (o°c)?
Yes/no
Good & PAss
XX.XXV XXXXsAe
Good & recHArGe
XX.XXV XXXXsAe
recHArGe &
retest
XX.XXV XXXXsAe
bAd & rePlAce
XX.XXV XXXXsAe
bAd cell &
rePlAce
XX.XXV XXXXsAe
code
XXXXXXXXXX
bAtterY test
XX.XXV
bAtterY tYPe
AGm flAt PlAte
bt2015 | issue:1 17/10/17
Advertisement
