Sealey ms155 Instructions

Thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. sAFETy
refer to
instruction
manual
9 K eep the extractor clean and maintain it in good condition (use an authorised service agent).
9
9
replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Keep all non-essential persons away from the work area.
9
9 c heck extractor connections and fittings before use.
9
9
9 e nsure that the tank capacity exceeds the amount of fluid to be collected.
9
9
9 D O NOT use the extractor for any purpose other than that for which it is designed.
9 8
9 D O NOT operate the extractor if any parts are damaged or missing as this may cause failure and/or personal injury.
9
9
9 W ARNING! Engine oil maybe hot when extracting.
ˆ
9
▲ ImpoRtANt! Ensure that you wear protective clothing, gloves, goggles, face mask as appropriate for the fluid being extracted.
9 W ARNING! Do Not allow uncontrolled discharge of fluids thus polluting the environment.
ˆ
9
dispose of waste fluids in accordance with local authority regulations.
9
9 W ARNING! Do Not use with gasoline or other flammable liquids.
ˆ
9
9 D O NOT use the unit to extract dangerous chemicals, poisons, acids, alkalines or solvents.
9 8
9 t he container is not designed for long term storage.
9 8
9 D O NOT store the unit under extreme conditions.
9 8
9 D O NOT turn the container upside down when it is holding fluids.
9 8
9 D O NOT adapt the unit for any other purpose.
9 8
9 W hen not in use, store in a safe, dry, childproof area.
9 8
2. INTRODUCTION
1.6 lt capacity, constructed from composite materials, suitable for the extraction of engine or transmission oils from cars, motorcycles, marine
engines, stationary engines and industrial machinery. Also suitable for low viscosity fluids such as water. Supplied with two suction probes
and cover cap. use probes to remove engine oil through the dipstick tube.
3. spECIFICATIONs
Model no: ...................................................................Ms155
capacity: ........................................................................ 1.6ltr
suction probes: ............Ø8mm x 1300mm, Ø5mm x 1008mm
© Jack sealey limited
instructions for
vACUUM OIL & FLUID EXTRACTOR MANUAL 1.6LTR
Ms155
model no:
Original Language Version
Fig.1
ms155| issue 1 22/07/15