Advertisement
TROUBLESHOOTING GUIDE
Follow the troubleshooting tips below. If troubleshooting techniques fail, bring
ballast back to your place of purchase to request warranty service.
POSSIBLE CAUSES CORRECTIVE MAINTENANCE
LAMP LOOSE
IN SOCKET
INCORRECT
VOLTAGE
DEFECTIVE
OR IMPROPER
WIRING
POOR ELECTRICAL
CONNECTIONS
INCORRECT LAMP Verify that you are using a 315 W Ceramic Metal Halide lamp.
LAMP
DAMAGE
RETURNING UNITS Please contact your retail store for returns.
WARRANTY This unit, when properly used will provide you with years of service.
It is covered under a 3 year warranty. This warranty will be voided if the unit is
misused, abused or altered. Warranty repair or replacement will be at the sole
discretion of the manufacturer. Defective units need to be returned to the place
of purchase with proof of purchase/receipt.
This warranty is expressly in lieu of all other warranties, expressed or implied, including
the warranties of merchantability and fitness for use and of all other obligations or
liabilities on the part of the seller. This warranty shall not apply to this product or
any part thereof which has been damaged by accident, abuse, misuse, modification,
negligence, alteration or misapplication. Manufacturer makes no warranty
whatsoever in respect to accessories or parts not supplied by manufacturer. This
warranty shall apply only to the United States, including Alaska, Hawaii and territories
of the United States and Canada. This warranty does not cover labor materials, travel
time, equipment, etc. to de-install any lighting fixtures or other equipment.
Part 18 compliance
Advisory statement
The interference potential
of the device or system
Maintenance of the system
Simple measures that can be taken
by the user to correct interference
This product contains delicate electronic components. This means that if it is placed
near an object that transmits radio signals, it could cause interference. This could
be, for example, mobile telephones, walkie talkies, CB radios, remote controls and
microwaves. If interference occurs, move such objects away from the appliance.
Make sure that the lamp is fully inserted into the socket and that is has been
locked in properly.
Make sure you are using the correct input voltage with ballast. If using
incorrect voltage, disconnect the ballast from the power source immediately.
Examine wiring to ensure it agrees with wiring diagrams on ballast label.
Check connections to see that they are secure. If wiring a 240V ballast,
DO NOT use a neutral. The correct wiring is two hot wires and a ground.
Check wiring and lamp contact with socket. Make sure the lamp cord is
firmly seated in output receptacle.
Investigate possibility of outer bulb damage.
Look for broken tubes or loose metal parts. Replace lamp.
This device complies with Part 18 of the FCC Rules.
This product may cause interference to radio equipment and
should not be installed near maritime safety communications
equipment or other critical navigation or communication
equipment operating between 0.45-30 MHz.
The interference potential of the device or system is the
operating frequency; < 9kHz.
Unplug the unit, wait 30 seconds, and plug the unit back in.
Move the unit away from any radio device.
Advertisement
