Galaxy LEC Installation And Operating Instructions

LEC
Installation/Operating Instructions
Galaxy LEC
®
906270 - 315 WATT 120V - 240V
906272 - 315 WATT 277V ONLY
READ THESE INSTRUCTIONS BEFORE FIRING UP YOUR BALLAST
KEEP ORIGINAL PACKAGING— all returns need to be in the original packaging
in order to avoid product damage during shipping. Any damage to products not in
their original packaging will not be covered under warranty.
SAFETY FIRST! Failure to observe the following safety warnings may result in
serious injury. In addition, failure to observe these safety warnings will result in a
waiver of all liabilities and will void all warranties.
WARNING
 If the exterior of the lamp is damaged, replace lamp immediately.
 When re-lamping, make sure lamp has time to cool before touching.
 Make sure lamp is correctly locked into the reflector socket, properly
securing the lamp.
 Make sure power cord and lamp cord are connected properly.
 Disconnect power before re-lamping.
 DO NOT hang by power or lamp cord.
 DO NOT make contact with the interior of the socket while power is on.
 DO NOT operate light systems in wet locations.
 D O NOT plug system into supply voltage other than what is designated on ballast.
 D O NOT attempt to rewire or reconfigure your system, it will void warranty and
could cause serious safety hazards (i.e. power cord, lamp cord, lamp socket or ballast).
 Keep away from children.
® Electronic Ballast
LIGHT EMITTING CERAMIC
:
®
®