Subscribe to Our Youtube Channel
Related Manuals for Envirco Hospi-Gard IsoClean 800
Summary of Contents for Envirco Hospi-Gard IsoClean 800
- Page 1 Hospi-Gard IsoClean 800 & IsoClean ® ® ® HEPA Filtration Systems INSTALLATION, OPERATION, AND MAINTENANCE MANUAL ENVIRCO Technical Support: 800-884-0002...
-
Page 2: Table Of Contents
Maintenance & Service..................... 7 Troubleshooting ........................11 Wiring Diagram ........................ 12 Specifications ........................14 Replacement Parts ......................15 Airflow Measurement & Testing ..................17 Air Change Rates ......................17 Limited Warranty ......................18 Contact Envirco ........................18 Innovators in Clean Air Technology | www.envirco.com... -
Page 3: Introduction
Hospi-Gard IsoClean 800 & 400 ® ® HEPA Filtration System I n s t a l l a t i o n , O p e r a t i o n , & M a i n t e n a n c e M a n u a l ■... -
Page 4: Installation
The shipping components list and actual material received should be compared and any shortages reported to Envirco immediately. Assembly The Hospi-Gard® lsoClean® is shipped completely assembled from the factory and requires no assembly. Every unit is tested prior to shipment to verify airflow and that the unit is leak-free. -
Page 5: Operation
Hospi-Gard IsoClean 800 & 400 ® ® HEPA Filtration System I n s t a l l a t i o n , O p e r a t i o n , & M a i n t e n a n c e M a n u a l ■... - Page 6 The air should not be recirculated into the general ventilation. ln certain cases in existing facilities, recirculation of air into the general ventilation system is unavoidable and, in such cases, CDC guidelines state that HEPA filters should be installed in the exhaust duct leading from the room to the general ventilation system. Innovators in Clean Air Technology | www.envirco.com...
-
Page 7: Maintenance & Service
NOTE: IT IS THE RESPONSIBILITY OF THE PURCHASER, AND NOT ENVIRCO, TO ENSURE THE ROOM IN WHICH THE UNIT IS USED IS IN COMPLIANCE WITH CDC GUIDELINES FOR A NEGATIVE PRESSURE ISOLATION ROOM AND MONITORED TO ENSURE ITS CONTINUING PERFORMANCE. - Page 8 Exterior cabinet cleaning must be performed with the unit running. Wipe the exterior of the unit with a damp sponge or cloth, paying particular attention to the prefilter intake grille. Rutala WA, APlC guideline for selection and use of disinfectants, Am J lnfect Control 1996 Aug ; 24(4): 313-42. Innovators in Clean Air Technology | www.envirco.com...
- Page 9 Hospi-Gard IsoClean 800 & 400 ® ® HEPA Filtration System I n s t a l l a t i o n , O p e r a t i o n , & M a i n t e n a n c e M a n u a l Prefilter Replacement The prefilter should be replaced every 60 to 90 days.
- Page 10 Remove the six (6) screws fastening the motor ring to the panel and remove the motor assembly from the unit. CAUTION: WHEN REINSTALLING THE MOTOR ENSURE THAT IT DOES NOT TOUCH OR PUNCTURE THE HEPA FILTER. Innovators in Clean Air Technology | www.envirco.com...
-
Page 11: Troubleshooting
Hospi-Gard IsoClean 800 & 400 ® ® HEPA Filtration System I n s t a l l a t i o n , O p e r a t i o n , & M a i n t e n a n c e M a n u a l Relocating a Contaminated Unit NOTE: USE PROPER PROTOCOL, GOWNING, AND PROTECTIVE MEASURES. -
Page 12: Wiring Diagram
Adjust the speed control down to the next lowest setting. Verify all filters are properly in place. Excessive Contamination Replace HEPA filter. Verify the HEPA filter is installed properly. ■ Wiring Diagrams IsoClean® 800 Wiring Diagram Innovators in Clean Air Technology | www.envirco.com... - Page 13 Hospi-Gard IsoClean 800 & 400 ® ® HEPA Filtration System I n s t a l l a t i o n , O p e r a t i o n , & M a i n t e n a n c e M a n u a l ■...
-
Page 14: Specifications
HEPA Filter Media: 99.99% at 0.3 micron minimum efficiency • Prefilter: MERV8 multi-pleat anti-microbial pleated prefilter with frame • Motor: 1/4 HP (0.19 kW), direct drive, three-speed, continuous duty • Exhaust Port: 6-inch (152.4mm) Duct Collar Innovators in Clean Air Technology | www.envirco.com... -
Page 15: Replacement Parts
Hospi-Gard IsoClean 800 & 400 ® ® HEPA Filtration System I n s t a l l a t i o n , O p e r a t i o n , & M a i n t e n a n c e M a n u a l ■... - Page 16 Germicidal Lamp 61528 Minihelic Gauge 63360 Keylock 61528 Minihelic Gauge 63360 Keylock For Isoclean 400 units purchased prior to February 2021, contact the factory for verification of correct motor, motor/blower, and capacitor parts. Innovators in Clean Air Technology | www.envirco.com...
-
Page 17: Airflow Measurement & Testing
Hospi-Gard IsoClean 800 & 400 ® ® HEPA Filtration System I n s t a l l a t i o n , O p e r a t i o n , & M a i n t e n a n c e M a n u a l ■... -
Page 18: Limited Warranty
Contact Envirco ■ For warranties, replacement parts, technical support, or any other questions please contact Envirco at 1-800-884-0002. For tech support related issues including troubleshooting and warranty, please email techsupport@envirco.com. For customer service related issues inlcuding parts ordering, please email customerservice@envirco.com. - Page 19 Hospi-Gard IsoClean 800 & 400 ® ® HEPA Filtration System I n s t a l l a t i o n , O p e r a t i o n , & M a i n t e n a n c e M a n u a l This page intentionally left blank.
- Page 20 DCM & RSR » AC or DC Control Systems Envirco USA 101 McNeill Road | Sanford, NC 27330, USA tel: 919.775.2201 | toll free: 800.884.0002 | fax:800.458.2379 www.envirco.com | customerservice@envirco.com or techsupport@envirco.com Copyright ©2013 Envirco. All Rights Reserved. Form P/N#: 267426...
Need help?
Do you have a question about the Hospi-Gard IsoClean 800 and is the answer not in the manual?
Questions and answers