Adjusting mirror arm
Slide protective cap 1 up over
screw connection on mirror
arm.
Loosen the nut 2.
Turn mirror arm into desired
position.
Tighten the nut to the spec-
ified torque while holding the
mirror arm to ensure that it
does not move out of position.
Locknut (mirror) on
clamping piece
Joint compound: Multi-Wax
Spray
Locknut (mirror) on
clamping piece
15 lb/ft (20 Nm)
Slide protective cap over
threaded fastener.
Spring preload
Setting
It is essential to set the spring
preload to suit the load carried by
the motorcycle. Increase spring
preload when the vehicle is heav-
ily loaded and reduce spring
preload accordingly when the
vehicle is lightly loaded.
Adjusting spring preload
at rear wheel
Remove the seat (
Remove toolkit 1.
58).
WARNING
Uncoordinated settings of
spring preload and spring
strut damping.
4
53
z