M-Audio Hammer 88 Pro User Manual page 33

Encoder Turn
To edit the turn functionality of the Encoder when in Preset Edit Mode, press and hold the
SHIFT button and move the ENCODER. You can scroll through the available parameter values
using the Encoder. Select what parameter you would like to edit by pressing the Encoder.
Channel: The Encoder will send its messages over this channel. Select the global channel
(Global), a specific channel (Channel 1–16), a zone (Zone 1–4), or all channels (Omni).
Available Values: Global, 1-16, Zone 1-4, Omni
Message:
•
Same as DAW "DAW": This assignment will match the message assigned to the Hammer
88 Pro's current DAW selection's Encoder.
•
Program Cycle "PRG CYCL": This is useful for selecting between different presets in
software or external MIDI hardware. Select from 2-4 program messages.
•
Program Inc/Dec "PG IN/DC": This is useful to scroll through multiple program
messages.
•
CC Cycle "CC CYCLE": This useful for controlling from 2-4 CC values, as seen on a
button or virtual instrument control with 2-4 parameters. Select from 2-4 values.
•
CC Inc/Dec "CC IN/DC": This is useful for scrolling through several CC values.
•
CC Relative "CC RELTV": This is useful for controlling endless Encoders in software.
Select from Right 65, Left 63; Right 63, Left 65; Right 127, Left 01; Right 01, Left 127.
When set to Program Cycle, these are the available parameters:
Values: The Encoder will cycle through this many Program values (one at a time) when you
turn it: 1 Values, 2 Values, 3 Values, or 4 Values.
Available Values:
•
2 Values
•
3 Values
•
4 Values
First: The Encoder will send this Program message first when you press it.
Available Values: 0-127
Second: The Encoder will send this Program message second when you press it.
Available Values: 0-127
Third: The Encoder will send this Program message third when you press it.
Available Values: 0-127
Last: The Encoder will send this Program message last when you press it.
Available Values: 0-127
33