Mounting The Brush Cutter Blade - Westfalia GM BFS 2T–26 Original Instructions Manual

Mounting the Brush Cutter Blade

Before mounting the blade, dismount the gear shaft from the
motor unit or remove the spark plug cap!
The cutting tool holder is equipped with left-hand thread.
The provided brush cutter blade is sharpened on both sided and can be
mounted inversed when worn. After both sides are worn, sharpen the
cutter blade or have it sharpened by a professional.
1. Insert the toothed locking disc on the
thread of the cutting tool holder (1).
2. Place the brush cutter blade on the tool
holder and then the lock washer (C).
Make sure the lock washer is placed
with the convex side up!
Lock Washer
3. Place the retaining disc (D) on the tool holder and
turn the hex nut (B) on the thread.
Attention LEFT-HAND THREAD!
4. To tighten the hex nut (B) use the included
combination wrench and turn the wrench counter
clockwise!
Mounting
Thread
12
Opening
Locking Disc
Hex Nut
Opening
Retaining Disc