Operation - EINHELL AV 10 Assembly And Operating Instruction

Anleitung AV 10 01.10.2003 15:19 Uhr
- To ensure that the aerosol is aimed in the
required direction, the diffuser must be
appropriately placed on the duct (Fig. 2)
- Push the base unit with the mounting on to the
wall bracket and push it down as far as it will go
(Fig. 3).
1
2
3
Seite 5
Installation on a living room wall
The AV 10 can also be installed on a living room
wall. Ensure that you do not damage any pipes or
cables.
- Secure the wall bracket in a suitable position on
the wall.
- Push the base unit with the mounting on to the
wall bracket and push it down as far as it will go
(Fig. 4).
- Remove the sealing cap in the cover.
4
To start the atomization, fill the unit as described in
the section entitled „Operation" and connect it to a
socket using the supplied safety transformer.

Operation

Fill the container with approx. 0.3 liters of water.
Ensure that you do not pour any fluid through the
openings in the sides of the casing since this may
damage the unit. If required an aroma concentrate
may be added (refer to the safety instructions). Close
the cover before you connect the unit to the power
supply. Switch on the unit.
GB
5