Installation - EINHELL AV 10 Assembly And Operating Instruction

Anleitung AV 10 01.10.2003 15:19 Uhr
GB
Foreword
The AV 10 aroma atomizer is a compact,
independent aerosol generator for use in heat
cabins, saunas and living rooms. It is designed for
the micro-atomization of fluids, including the aromatic
additives in them, such as herbal extracts and
essential oils.
The active agents are released in a gentle process
that does not involve heating them. The unit is ideal
for aromatherapy in an infrared cabin and sauna. To
meet the tight space requirements, the aroma
atomizer was designed for mounting on the outside
of the cabin. It can be removed easily for filling and
cleaning and is extremely simple to handle. A
variable diffuser nozzle enables the user to direct the
stream of aerosols as required into the cabin or to
insert it straight into the convection current from a
sauna heater. As a result of its constructive design it
allows an infrared cabin or sauna to be aromatized in
all modes of operation - even in Finnish mode. To
enhance the atmosphere in living rooms the AV 10
can be mounted on any wall in the room, thus
exerting a positive effect on your feeling of well-being
at home.
As a result of its easy installation the AV10 is ideal
for retrofitting.
The functions of the unit include the
following:
Energy-saving atomization using ultrasound.
Evaporation capacity of approx. 0.65 l/hour.
Atomization and evaporation of a wide range of
aromatic substances and active agents, such as
essential oils or herbal extracts.
Gentle release of active agents - aromatic
substances are not heated and therefore remain
complete, thus retaining their full effect (no
change in the active agents).
Optimal distribution of the sauna vapor and the
healing and active agents through a diffuser
nozzle.
User-friendly handling.
Easy to clean since the entire unit can simple be
removed.
Immediate aerosol development with no start-up
time.
4
Seite 4
Safety functions
Automatic cut-out if the water level is too low.
TÜV GS-approved with safety transformer.
Added safety due to its being an extra-low voltage
unit.
Mechanical/technical properties
Durable unit due to its sturdy design.
Very simple to install and start up.
Safety instructions
- Only use perfumes and aromatic substances from
Weka.
- Do not exceed the dosages specified on the pack.
If you ignore these instructions there is risk to life.
Technical data
Mains voltage
Operating voltage
Max. rating
Protection type
Delivery
1 Base unit
1 Wall bracket for installation in a sauna
1 Wall bracket for installation on a room wall
1 Safety transformer
1 Bag with fastening material

Installation

Installation in a sauna
The AV 10 can be installed at any point in the sauna.
Ensure that the hole you drill through the wall does
not damage any existing installations (electric
cables). We recommend that you use a position that
has good access to facilitate the handling of the unit.
- Drill a 24 mm hole in a suitable position.
- Push the wall bracket with the duct from the
outside through the hole and secure it with the
two screws (Fig. 1). Note: If required the duct can
be reduced to suit the thickness of the sauna wall.
AC 230V 50Hz
AC 24V
25W
IPX4