Advertisement
Available languages
Available languages
Setting
min
med
max
In 3 speed stage mode, the settings are c1, c2 or c3 for the
relevant pump curve.
NOTE: When the knob is turned to the middle position, the
pump runs at minimum speed.
Factory setting: ∆p-v, ½ H
NOTE: All settings and displays are retained if the mains
supply is interrupted.
6 Maintenance/faults
DANGER: Before starting any maintenance and repair
work, disconnect the pump from the power supply, and
make sure it cannot be switched back on by unauthor-
ised persons. Damage to the connection cable should
always be repaired by a qualified electrician. Have faults
remedied by qualified skilled personnel only!
WARNING: Depending on the pump or system operating
conditions (fluid temperature), the entire pump can
become very hot. Touching the pump can cause burns!
When removing the motor head or pump, hot fluid may
spurt out under high pressure. Allow the pump to cool
down beforehand.
Close the stop valves before removing the pump.
Inside the machine there is always a strong magnetic
field that can cause injury and damage to property in the
event of incorrect dismantling.
Installation and operating instructions
Delivery head (m)
0.5
½ H
max
H
max (nominal delivery head at Q = 0 m
max
English
3
/h)
11
Advertisement
