HEIRLOOM 101 Series Quick Start Manual

101 Series Basin Mixer/ Sink Mixer
Pressure Rating:
Hot Water Temperature:

Hole Diameter

Cleaning:
Pre Installation Inspection:
Installation:
Version 1
Mains Pressure – Equal
Maximum operating pressure 500KPa.
Minimum operating pressure 150 Kpa.
If supply pressure exceeds the maximum limit a limiting valve must
be installed
Maximum continuous working temperature 70
Min 35 mm/Max 40 mm and maximum bench thickness 45 mm
Clean with soft cloth and a mild liquid detergent or soap and water.
DO NOT use cream cleaners or citrus based cleaning products or
ammoniated products. Use of unsuitable cleaning agents may
damage the surface. Any damage caused form unsuitable cleaning
products or methods will not be covered by warranty.
Product must be inspected prior to installation. Any suspected
defect in the product must be notified to Heirloom as soon as
possible after discovery. If a defect is found the product must not be
installed. Should it be installed despite a defect being identified, or
with a defect that ought to have reasonably been identified, then
Heirloom warranty cover will not extend beyond the product and
only the product.
[Diagram here]
Product must be installed to the requirements of AZ/NZS 3500 and
any local authority requirements. Do not dismantle the cartridge or
other internal parts as the mixer is factory tested and sealed for best
performance.
IMPORTANT: Ensure pipework is free of debris by flushing the lines
prior to installing the product. Failure to do so may result in
cartridge damage that is not covered by warranty
Cut a mounting hole to the correct diameter
Fit O ring to base plate
Screw the threaded studs into the mixer base
Position the mixer over the mounting hole and feed the hose
through the mounting hole
July 2018
o
www.heirloom.co.nz