HEIRLOOM CARLTON Installation Instructions

Ladder towel warmer

Advertisement

Quick Links

CARLTON LADDER TOWEL WARMER
The Advanced Art of Towel Warming

Operation

Your CARLTON Towel Warmer uses only minimal electrical power - about the same as an average light bulb. It will take
approximately 20-30 minutes to reach maximum operating temperature. CARLTON Towel warmers are designed for
continuous operation. NOTE: The temperature of your towel warmer will vary with the ambient temperature of your room. A
towel warmer is designed to warm and assist the drying of towels and will normally operate at a temperature that is too hot for
the warmer to be grasped. For complete temperature control a suitable Wall Mounted dimmer switch (with "off" position) is
recommended.

Locating Instructions

Detailed installation instructions are provided on the reverse side. The CARLTON Ladder Towel Warmer should be fixed
through the wall cladding directly to studs or other suitable anchor material. The towel warmer should be located in
compliance with the AS/NZS 60335 Standard and should not in any circumstances be located in the direct path of a water
source (tap or shower etc). CARLTON towel warmers have an IP45 rating offering you the greatest flexibility to safely locate
the towel warmer in bathrooms or shower rooms in Zone 1-3. All other electrical fittings must also be compliant with the zone
within which the warmer is being installed.
Electrical Installation: NOTE : This towel warmer is made in right hand wiring only.
Please ensure your towel warmer is installed by a registered electrician and ensure the electrical supply, plug & switch
location, and product location will comply with your local regulations.
New Zealand electrical wiring requirements stipulate that this appliance must be wired by a registered electrician in
accordance with current electrical wiring regulations. This appliance must be fitted with an air gap phase isolation switch
which isolates the phase & neutral in accordance with local wiring regulations. This product must be used in conjunction
with a hard wired switch. For complete temperature control a Wall Mounted dimmer switch (with "off" position) is
recommended.

Concealed Wiring Kit

A concealed wiring adapter kit is included with this product. If you have access to the wall cavity the kit allows you to conceal
the electrical flex for a more streamlined and visually appealing installation.

Care and Cleaning

The polished stainless steel finish of your Towel Warmer is hard wearing and easily maintained. Clean regularly with a soft
cloth and non-abrasive cleaning agent.

Warranty

This product is warranted against defects due to faulty workmanship or materials for 5 years from date of purchase. In the
event of a defect in the product, turn it off at the wall, and contact the retailer from which it was purchased and provide details
from your sales receipt and the products serial number from the label on the towel warmer. The retailer will contact Heirloom
who will assess the matter and if accepted as a valid warranty claim the product will be repaired or replaced at Heirloom's
option – free of charge. Costs of disconnection, reconnection, and freight are the responsibility of the owner, as is any
damage arising in transit to and from servicing by Heirloom. This warranty does not cover:
a. Any damage to the product caused by misuse, neglect, accident, or in violation of the manufacturer's instructions, or
b. Any damage, loss or injury arising as a consequence of the use of the product.
Australia: Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to
a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are
also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not
amount to a major failure.
Heirloom International Limited, P O Box 204 235, Auckland 2161, New Zealand.
Ph +64 9 274 4443 info@heirloom.co.nz
Contact Us
We welcome your feedback on our products. You can view our full range of towel warmers on our website and send us your
comments about this product using the Contact Us page on our website www.heirloom.co.nz
CARLTON NZAust v1.3 Nov 2019
Page 1 of 3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CARLTON and is the answer not in the manual?

Questions and answers

Summary of Contents for HEIRLOOM CARLTON

  • Page 1 The Advanced Art of Towel Warming Operation Your CARLTON Towel Warmer uses only minimal electrical power - about the same as an average light bulb. It will take approximately 20-30 minutes to reach maximum operating temperature. CARLTON Towel warmers are designed for continuous operation.
  • Page 2 1 x Handle for Allen keys CAUTION: Prior to installation please ensure the product is to your satisfaction. Once installed Heirloom cannot be responsible for defects in the product finish. This product is not intended for use by young children or infirmed persons without supervision. Young children should be supervised to ensure they do not play with the product.
  • Page 3 CARLTON Towel Warmer Concealed Wiring Option Instructions Preparation for concealed wiring must commence before the wall cladding is in place. Ensure that the flush box that the towel warmer will be wired to is within this distance of the electrical flex from the towel warmer, to which it must connect.

This manual is also suitable for:

Wca1000

Table of Contents