Related Manuals for Cell2 SDA100W
Summary of Contents for Cell2 SDA100W
- Page 1 SDA100W Siren Amplifier Installation & Operation Manual NOTICE TO INSTALLER Before installation and operation ― read all instructions and warnings. Deliver this manual to the end user of this product.
-
Page 2: Table Of Contents
3. Failure to follow these instructions could result in serious damage to the unit or vehicle and may void warranties. 4. The correct mounting and wiring is the key to the effectiveness of SDA100W. 5. Installers must read and follow instructions and warnings in the manual from the original manufacturer. -
Page 3: Contents, Specification
Microphone x 1 pc Microphone clip x 1 pc Sheet metal screws x 3 pcs (ø4 x 16mm) Accessory (Optional) SDA100W Siren Amplifier Installation & Operation Manual NOTICE TO INSTALLER Before installation and operation ―... -
Page 4: Mounting
MOUNTING ● Siren amplifier 1. Select a location that is not exposed directly to weather elements, such as the driver compartment firewall, below the seat, or in the trunk; avoid any interference of air bag deployment. 2. Using the siren amplifier as a template, mark four mounting holes to be drilled. 3. -
Page 5: Wiring
WIRING ● Wiring diagram: POWER I / O FUSE BLACK – Power -GND Mic Volume RED – Power +VDC Adjustment Knob (Fuse Rating: Microphone 15 A @ 13.6VDC) RJ45 Connector Connector B Connector A Battery PINK – HORN RING TRANSFER(HRT) INPUT Hand-held Mic HRT Input Connection Momentary Foot Switch... - Page 6 Control Wire Harness (Connector B) ● Speaker Out Connect the LIGHT BLUE (SPK+) and BLUE (SPK-) wires to one 100W 11-ohm impedance speaker. ● Ignition Activation (IGN) input Apply +VDC continuously to RED wire to enable the siren system. Connect this wire to a positive circuit controlled by the vehicle ignition switch to allow the siren amplifier to be turned on &...
-
Page 7: Tone Table
TONE TABLE To change the Tone Group, see next page for corresponding DIP Switch setting. ENABLE HRT, ENABLE HRT, ENABLE HRT, DISABLE/ ENABLE No. COUNTRY TONE CYCLE/MINUTE SIREN ON, SIREN OFF, SIREN OFF, MIX TONE DAY/NIGHT WIRE INTERLOCK ON INTERLOCK OFF INTERLOCK ON WAIL 12 C/M YELP... - Page 8 ● Tone Group Selection Carefully check and change the DIP Switch #1 to #5 according to your required tone. Restart the unit after setting to apply the change. DIP Switch #6 is for HRT setting; see previous page. DIP SWITCH COUNTRY TONE FREQUENCY(Hz)