Access Tigris Instructions

Cylinder Instructions
Access2 Ltd
0191 215 0530
GENERAL
These instructions are suitable for all
Standard Differ, Masterkeyed and 1 & 3
Star Security Cylinders.
Care should be taken to prepare
doors accurately and to fit lock cases
squarely within the door. Cylinders
should not be forced into position as
this could damage the cylinder and
prevent its proper functioning.
On completion of installation, this
guide should be passed to the building
owner for maintenance guidance.
For further information please go to:
www.access2.com
Note that single cylinders can have
alternative cam positions (Tigris ® Plus
and Tigris ® Premier only).
4
5
3
2 6
1
7
8
INFORMATION ON SECURITY CYLINDERS
This cylinder offers
resistance to the
commonly used types
of attack. No specific
security hardware is
required, but installing a three star
cylinder in conjunction with security
hardware complying with TS007 will
1 Star Security Cylinders 3 Star Security Cylinders
increase attack resistance still further.
Security hardware can be of several
types, including a handle with a
reinforced backplate, an escutcheon
or a device which is concealed behind
the handle backplate. In all cases, the
purpose is to protect your cylinder
from force attack.
!
Three Star cylinders have a
SNAP feature which must be
on the external face of the
door. Take special care on installation
to avoid damaging the cylinder or
activating the SNAP feature through
the use of undue force.
Note: If a thumbturn cylinder is
attacked it will lock in position. To
release the cylinder you must either
pull or push the thumbturn (model
dependant) and then turn to release.
PLEASE CHECK YOUR MODEL OF
CYLINDER.
This cylinder offers
resistance to many types
of attack. It is designed
to be used in conjunction
with two star security
door hardware to ensure enhanced
resistance to all commonly used attack
methods. Therefore this product MUST
1 Star Security Cylinders 3 Star Security Cylinders
be used in conjunction with two star
security door hardware meeting TS007
to ensure security.
Such hardware can be recognised
by the two star marking which may
either be visible from the outside on
an installed handle or, failing this, will
be visible once the outside handle has
been removed.
Security hardware can be of several
types, including a handle with a
reinforced backplate, an escutcheon
or a device which is concealed behind
the handle backplate. In all cases, the
purpose is to protect your cylinder
from force attack.
MAINTENANCE
DO NOT lubricate the cylinder with oil
or graphite.
Clean and lubricate cylinders every 6
months using Tigris® spray lubricant
only.
Cylinders with Classroom Function
are designed so that the turn will only
UNLOCK the door and are therefore
only used in an emergency. As the
thumbturn is rarely used, it is VITAL
that AT THE END OF EACH TERM (or
every three months) that the cylinder
is lubricated, the deadbolt is thrown
to the locked position by key with the
door ajar and the thumbturn is used to
withdraw the deadbolt.
Further information on warranty and
warranty care and lubrication cycles is
available on www.access2.com/Page/
MasterkeyDocumentLibrary.aspx