JVC KW-V40BT Instruction Manual page 50

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Installation procedure
1
To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wiring harness wires in the
following order: ground, battery, ignition.
5
Connect the wiring harness connector to
the unit.
6
Install the unit in your car.
7
·
Reconnect the battery.
8
Press the reset button.
9
Configure <Initial Settings>. (page 4)
50
Installing the unit
Installing the unit (only for KW-V40BT
·
Region 4/KW-V20BT Region 4/KW-V10
Region 4)
• Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
When installing the unit using the
mounting bracket removed from the
car
5 or 6
• Select the appropriate type of screw for the
mounting bracket: flat head (5) or round head
(6).
Installing the trim plate (only for KW-
V40BT Region 4/KW-V20BT Region 4/
KW-V10 Region 4)
1
Attach the trim plate (
Car Bracket
5 or 6
).
2
2