Table of Contents
Advertisement
Closing the server
a
Figure 25: Installing the server
Ê Press the locking springs (a).
Ê Slide the server into the rack (1) until the telescopic bars click into place.
I
After you have inserted the server, you should pull it out again as far
as it will go and then push it back in. This ensures that the server runs
cleanly on the telescopic rails.
Ê Fasten the server at the front using the two knurled screws (2).
Ê Plug in the power plugs and switch the server on.
46
Options Guide
Completion
RX220
Advertisement
Table of Contents
