Advertisement
Removing and Installing Battery
NOTE: VERSAPAK‰ Batteries are not fully charged at the factory.
To install the battery into the ZMT 300, simply slide it into the
handle until it clicks into place. To remove the battery, press the
release button and pull.
Switch
To turn the ZMT 300 ON in a forward direction, slide the switch
button to the right and align it with the arrow pointing forward.
Depress the switch button and the ZMT 300 will run. Release the
button and the rod will stop.
To operate in reverse, slide the switch button to the left and align it
with the arrow pointing backward. Depress the switch button and the
ZMT 300 will run. Release the button and the rod will stop.
VELUX America Inc.
V-USA-0726-0906
© 2006 VELUX GROUP
Cleaning
Use only mild soap and damp cloth to clean the tool. Do not immerse
any part of the ZMT 300 into water or let water get inside.
The RBRC Seal
The RBRC‰ (Rechargeable Battery Recycling Corporation) Seal on
the nickel-cadmium battery (or battery pack) indicates that the
costs to recycle the battery at the end of its useful life has already
been paid. In some areas it is illegal to place spent nickel-cadmium
batteries in the trash or municipal solid waste stream. The RBRC
program provides an environmentally conscious alternative .
1-800-88-VELUX
www.veluxusa.com
VELUX Canada Inc.
® VELUX, VELUX logo are registered trademarks of VELUX Group
Advertisement
