Charging The Battery; Using The Appliance - Profi Care PC-PR 3025 Instruction Manual

Indicator Light
The indicator light colours have the following meanings:
Red = Charging process
Green = Charging process finished
Blue = Operating mode, adjustment of levels

Charging the Battery

NOTE:
The appliance is equipped with deep discharge protection.
This turns the appliance off if the charging for operation is
no longer sufficient.
1. Insert the charging cable into the power adapter.
2. Connect the power adapter with the connecting socket of
the appliance.
3. Plug the power adapter into wall outlet. Charge the
appliance before first use for 2.5 hours.
NOTE:
• The indicator light remains red during the charging
process.
• The charging process is finished when the indicator
light illuminates green.
• Mere mains operation is not possible.
4. Disconnect the power adapter from the outlet once the
rechargeable battery has been charged completely.
NOTE:
Even when switched off, the rechargeable battery dis-
charges continuously. If the appliance is out of use for a
longer period of time, charge the rechargeable battery at
least once every 4 to 8 weeks.

Using the Appliance

WARNING: Risk of injury!
• When using the appliance for the first time, test the
attachment on your forearm before using it on your
face. Lead the appliance along your arm and then wait
approximately an hour. If a skin reaction which could
appear then subsides, you can use the appliance on
your face.
• Do not use the appliance over and under the eyes!
If you treat the fine lines beside the eyes, cover the
eyelid with a finger of the other hand and move the
appliance from you finger towards the temple.
• Avoid using directly at the lips and under the nose.
(Painful)
• Always begin using the lowest suction level! Too much
suction strength can cause hematomas. Increase the
suction strength only gradually.
• Do not hold the appliance against one portion of the
skin as soon as you have turned it on!
44
PC-PR3025_IM
1. Clean your face and dry it off completely before each use.
To open the pores, you can take a hot steam bath
beforehand or keep a warm, damp cloth on your face
for a while.
2. Put on the desired attachment. Make sure the sealing
rings don't slip.
3. Turn the appliance on using the on / off switch . If
necessary, select another suction level.
4. Touch your face with the attachment so that you can feel
the effect of the suction. Do not press the attachment too
firmly against the skin and do not hold it in one place!
Move the attachment in straight lines in one direction.
Treat all areas on the face apart from the eye area. The
following describes how to move the appliance in each
area:
- Chin: From the middle outwards
- Cheeks: From the nostrils toward the ears
- Forehead: From the middle outwards
- Nose: From top to bottom and along the nostril
- By the ears: Along the temples from bottom to top
NOTE:
• In some areas, it is more difficult to establish full
contact with the skin. Try to hold the appliance in
different ways. Move the appliance vertically or hori-
zontally, or turn just your head in order to establish
better contact with the skin.
• Your skin may be reddened following use. This is
normal and should (depending on skin type) sub-
side again within a few hours.
5. If you wish to stop the use, turn the appliance off using
the on / off switch .
6. Following use, wash your face with cold water so that the
pores close up again. Finally, apply a care product with
sunscreen protection.
Changing the Filter Sponge
Please refer to the image on page 3.
NOTE:
Pay attention to the correct fitting of the sealing rings.
1. Remove the attachment.
2. Remove the closure.
3. Remove the dirty filter sponge with a tweezers and insert
a new one.
4. Put the closure and the attachment back on.
15.02.18