THERMOBIND TB240S Operating Instructions

Automatic Shutoff

If a cover is left in the machine after binding the machine will
automatically cool down. If the machine is empty but is not
used for fifteen minutes it will automatically shut off. To
restore power, turn the machine off and then on again.
Customer Support
We're committed to helping our customers get the best
binding results. Please call us toll free at 888-992-4144 if you
are not getting the results you expect and we will troubleshoot
the problem with you live. Our hours are 9:00 AM to 5:00PM
Eastern time, Monday through Friday. You can also email
sales@thermobind.com for a prompt reply.

Basic Machine Maintenance

We're committed to helping our customers get the best
binding results. Please call us toll free at 888-992-4144 if
you are not getting the results you expect and we will
troubleshoot the problem with you live. Our hours are
9:00 AM to 5:00PM Eastern time, Monday through Friday.
You can also email sales@thermobind.com for a prompt
reply.
USER GUIDE FOR THERMOBIND TB240S
Operating Instructions:
1.Plug directly into an 120Volt outlet. Turn on the power switch
located at the right rear. There is no warm up time.
2.Turn the "SELECT" button to select your choice of " Paper
covers",60 seconds,"Steel Spines" 90 seconds , or "Albums", 120
seconds. You'll only use the 120 seconds for Pro-bind or CoverbInd
hard covers or glue strips.
3. Fill your thermal binding cover(s) with the sheets you wish to
bind. Place the cover(s) into the machine with the spine resting
squarely on the heating plate.
4. An electric eye will cause the cycle to begin when the covers are
inserted into the machine.
5. The machine will beep when the cycle is done.
6. Before removing the booklet(s) from the machine, push down on
the pages while holding the front and back covers firmly so that you
can be sure that all the pages are making contact with the melted
adhesive.
7. Remove the bound book(s) from the machine. Place it in the
cooling rack and leave it for about 5-10 minutes. Do not try to open
the book(s) until it has thoroughly cooled.
8. To continue binding, please repeat steps 3 through 7.
9. Turn the machine off after binding.
5/13/20