Westfalia Bell Safety Notes / Operating page 5

Westfalia – LED Light Chain "Bell" – Article No. 80 01 73
Do not operate the article while it is in the packaging.
Do not connect the article electrically with other light chains.
Make sure the cable cannot become a tripping hazard. Do not bend the
cable. Do not use the article, if the outer shell, the power cable or the
plug are damaged. Do not clamp the cable and do not overstretch it.
Do not expose the article to strong mechanical stresses or strong
vibrations.
Do not cover the article when it is switched on and do not put or hang
any objects on the article.
Do not disassemble the article and the power supply or attempt to
repair it yourself. It does not contain parts serviceable by you. In the
case of questions or problems, turn to our customer support.
Use the article only on normally flammable or flame resistant
surfaces.
Installation
1. Take the article out of the packaging.
2. Unwind the wire of the article as far as necessary.
3. Connect the two-pole plug at the end of the article with the power
supply. Turn the cap nut on the plug hand tight, to protect the
connection against humidity.
4. Plug the power supply into a power outlet in order to take the article
into operation.
Safety Notes / Operating