Table of Contents
Advertisement
1. Safety Instructions
The scanning head TK326 is developed only for scanning of rotor marks and LED's of electronic
meters.
It is not allowed to modify the TK326 in any way.
Only electrically skilled person (older than 18 years) having relevant education and experience
which enable him/her to perceive risks and to avoid hazard/damage which electricity can create, are
allowed to operate the equipment.
Every person putting this equipment into operation, operating or servicing the system should read,
understand and follow the user manual including all safety instructions. Use of equipment tools,
cables in a manner not specified may damage the protection provided by the equipment.
Also observe the local safety regulation, general guideline for accident prevention, general guideline
for safety engineering regulations.
If the units appears to be damaged or operates abnormally, protection may be impaired. Do not
attempt to operate it and report the defect or damages to the supervisor in-charge immediately. The
test operation has to be stopped until defects and damages have been repaired and removed.
This operation manual has to be kept close and accessible to the tester at any time.
The protective earth conductor of the meter test system should be connected with the
protective earth conductor of the main supply. This is necessary to safe against
unintended contact.
Scanning Head TK326
TK326_MAN_EXT_GB_V102
3
Advertisement
Table of Contents
