Table of Contents
Advertisement
Quick Links
Window Blind Replacement
for Andersen
E-Series Casement Windows with System 3 Blinds
®
Thank you for choosing Andersen.
For questions call 1-888-888-7020. For more information and/or guides visit www.a nd ers enw i ndows . co m.
Please leave this guide with building owner.
▶ Read guide from beginning to end before starting installation. Read all warnings and cautions during unit installation.
▶ Check with your local building code official to identify and confirm compliance with local building code requirements.
Parts Included
(1) Replacement Blind
Tools Needed
∙ Safety Glasses
∙ Phillips Screwdriver
∙ Flat Blade Screwdriver
∙ Needle-nose Pliers
∙ .050" Hex Key
Use caution when working at elevated heights and around unit openings.
Follow manufacturers' instructions for ladders and/or scaffolding. Failure
to do so may result in injury or death.
"Andersen" and all other marks where denoted are trademarks of Andersen Corporation and its subsidiary. ©2018 Andersen Corporation. All rights reserved.
Replacement Blind
Follow manufacturers' instructions for hand or power tools. Always
wear safety glasses. Failure to do so may result in injury and/or
product damage.
90 69 2 6 5 BA - 0 0
Revised 01/19/18
Advertisement
Table of Contents
Related Manuals for Andersen E Series
Summary of Contents for Andersen E Series
- Page 1 “Andersen” and all other marks where denoted are trademarks of Andersen Corporation and its subsidiary. ©2018 Andersen Corporation. All rights reserved. 90 69 2 6 5 BA - 0 0...
- Page 2 Interior Interior Cord Retainer Clip Blind Cords Unwrap lift blind cord from cord retainer clip and slowly lower the Unlock and open sash. blind. ▶ Proceed to step 2 for windows WITH insect screens. ▶ Proceed to step 5 for windows WITHOUT insect screens. Window Frame Interior Interior...
- Page 3 Interior Interior Control knob hanging over edge of table Tilt Control Cable .050" Hex Key D-rod Lift blind panel out of window sash. Lay on a clean flat surface with the Disconnect the tilt control cable from the D-rod located along the top interior surface face down.
- Page 4 Split in cord pass through grommet must be positioned to face toward sash. Failure to Interior Interior do so will result in damage to cords. Blind Panel Frame Blind Panel Frame Grommet Insert blind cords and re-insert blind panel grommet into hole in blind Push the blind assembly toward top of blind panel and snap into panel frame.
- Page 5 Interior Interior Lift up and toward sash on lift bar at bottom of insect screen to seat Close and lock window. insect screen into window frame. Interior Cord Retainer Clip Blind Cords Check for proper operation. Secure blind cords to cord retainer clip. ▶...
Need help?
Do you have a question about the E Series and is the answer not in the manual?
Questions and answers