Advertisement
3.2
cREATIon oF 3/16" SAE SIngLE FLARE
3.2.1
Use the SAE tool, stop and double ended
punch as shown in fig.1.
3.2.2
The stop must be screwed into the tool to
within 5mm of the hexagon.
3.2.3
Slide the tool onto pipe.
3.2.4
Tighten the locking screws by hand, just enough
to grip the pipe.
3.2.5
IMPORTANT! DO NOT over tighten at this stage
or the stop will damage the pipe.
3.2.6
Screw the stop into the tool until fully tightened.
(A 16mm ratchet spanner is recommended,
but not included.)
3.2.7
Tighten the locking screws fully to clamp the
pipe. (A 10mm ratchet spanner is
recommended, but not included.)
IMPORTANT! If the locking screws are not
tight enough then the pipe will push back
during the flare process and will not
produce the correct flare.
3.2.8
Undo and remove the stop.
3.2.9
Insert the oP1 end punch and tighten fully up
to the hexagon in order to form the flare.
3.2.10 Unscrew the punch. The single flare is now
complete.
3.2.11 Undo the locking screws and remove the tool
from the pipe.
3.3
cREATIon oF 3/16" SAE DoUBLE FLARE
Firstly follow steps 3.2.1 to 3.2.10. to form a
single flare.
3.3.1
Reverse the punch and insert the oP2 end into
the tool and fully tighten up to the hexagon in
order to form the flare.
3.3.2
Unscrew the punch.
3.3.3
Undo the locking screws and remove the tool
from the pipe. The double flare is now complete.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey Limited
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
Note:
A spot of grease on the end of the
punch helps the flare process.
PUncH
SToP
01284 757500
01284 703534
DIE JAWS
LocKIng ScREWS
.
www.sealey.co.uk
Web
sales@sealey.co.uk
email
PFT12
Issue: 1 - 06/09/12
Advertisement
