Pro Lite Digi-Brite G3i Wiring Manual page 20

DON'TS
 Do not cut into the Gas Pricer PCB at any point.
 Do not drill into the Gas Pricer PCB.
 Do not cut/modify any part of the Gas Pricer extrusion.
 Do not cut/modify any part of the Gas Pricer mounting brackets.
 Do not use any other power supply type to power the Gas Pricer units other than the ones supplied.
 Do not use the provided power supplies to power any other lighting in the sign cabinet.
 Do not install the provided power supplies lower than 2" from the bottom of the cabinet.
 Do not touch the Gas Pricer LED bulbs during installation.
 Do not install the provided power supplies more than 15 feet away from the Gas Pricer units.
DO'S
 Do mount the provided power supplies in the lower half of the cabinet at least 2" from bottom.
 Do handle the Gas Pricer units by the corners.
 Do install forced or passive venting to keep the cabinet temperature below 160˚F.
 Do make sure there is no exterior water dripping into the cabinet
 Do make sure that the brightness level setting of the Gas Pricer units are set to 1.
Page 18